Setting A Scsi Channel's Terminator - Acer AcerAltos 3102RS User Manual

Setting a SCSI Channel's Terminator

Press ENT for two seconds to enter the
Main Menu. Press t or s to select "View
and Edit SCSI Channels", then press
ENT.
SCSI channel information
displayed on the LCD. Press t or s to
browse through the information of every
SCSI channel. Press ENT on a channel
you wish the terminator mode changed.
Press t or s to select "Set SCSI
Channel Terminator", then press ENT.
The current status of the SCSI terminator
will be displayed on the LCD. Press ENT
to continue.
Press ENT again for two seconds to
change the terminator mode to the
alternative option.
Only a terminator with Single-Ended channel can
be enabled/ disabled through the setting shown
above.
A terminator with Differential channel must be
removed/ installed physically from the board. The
LCD will show this as "Diff".
Chapter 7 General Front Panel Operation
View and Edit
SCSI Channels
will be
CH0=Host
SID=NA SXF=20.0M
Set SCSI Channel
Terminator
SCSI Terminator
Enabled
CHL=0
Terminator
×
PID=0
..
..
Disable
?
105