Table of Contents
Advertisement
Quick Start
To set up the redundancy function of the controllers, you must perform
a few basic steps. These steps will be described later in this chapter.
1. Cable connections
Redundant Controller Cable
RS-232C Cable (for Terminal Interface Operation
SCSI Cables
2. Controller settings
Communication Parameters
Redundant Configuration
*
The redundant function of the controllers can be enabled on the front panel or a
terminal interface. The following describe the procedures when using the front
panel. Similar menus and messages are displayed when using the terminal
interface. The same result can be achieved regardless of the method used.
Connecting an RS-232C cable when using the terminal interface is highly
recommended but is not essential for the redundant controller's functionality.
Chapter 9 Redundant Controller
)
*
187
Advertisement
Table of Contents
