Acer AcerAltos 3102RS User Manual page 16

Delete the Slot Number .............................................240
Remove Empty Drive Entry .......................................240
Set Each Fault-bus Error Signal Input as Active-high
or Active-low.........................................................241
Enable Each Fault-bus Error Signal Input .................241
Test Drive Failure LED for Each Drive Canister........242
Viewing the Status of Each Fault-bus Error Signal
Input .....................................................................243
Viewing the Status of Each Fault-bus Error Signal
Input .....................................................................243
Configuring on the Controller through the RS-
232C Terminal Interface.................................. 244
Assign Each SCSI Drive or Canister a Slot Number.244
Assign a Slot Number to an Existing SCSI Drive ......244
Assign a Slot Number to an Empty Canister.............245
Add Drive Entry .........................................................245
Delete the Slot Number of a SCSI Drive or Empty
Drive Entry ...........................................................246
Remove Empty Drive Entry .......................................247
Set Each Fault-bus Error Signal Input as Active-high
or Active-low.........................................................248
Enable Each Fault-bus Error Signal Input .................249
Test Drive Failure LED for Each Drive Canister........249
Viewing the Status of Each Fault-bus Error Signal
Input .....................................................................250
Appendix A Front Panel Navigation Map
Appendix B SCSI Cable Specifications
xvi