Table of Contents
Advertisement
Choose "Maximum Drive Capacity", then
press ENT.
Use t and s to change the maximum
size that will be used on each drive.
The Local Spare Drive can also be
assigned here. Press t or s to choose
"Spare Drive Assignments", then press
ENT.
The currently available drives will be
shown on the LCD. Use t or s to
browse through the drives, then press
ENT to choose the drive you wish to
serve as the Local Spare Drive. Press
ENT again for two seconds.
Press ESC to return to the previous
menu. Use t or s to choose "Create
Logical Drive", then press ENT for two
seconds to start initializing the logical
drive. The desired capacity of the drives
will be used in this logical drive.
The Controller will start to initialize the
parity of the logical drive. Please note
that if NRAID or RAID 0 is selected,
initialization
time
is
completes immediately.
The LCD will display the logical drive's
information after completing initialization.
Chapter 7 General Front Panel Operation
Maximum
Capacity
MaxSiz=
Set to
Spare Drive
Assignments
C=1 I=15
*LG=0 SL SEAGATE
Create Logical
Drive
Init Parity
Please Wait!
shorter
and
LG=0 RAID5 DRV=3
2012MB GD SB=0
Drive
..
1010MB
1010MB?
..
1010MB
?
90%
83
Advertisement
Table of Contents
