Film Threading - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
2-4. Film Threading
2-4. Film Threading
This unit is designed so that the film cannot be driven unless the front door is closed due to the danger of
touching the film driven with the hand, etc.
For this reason, stop running when removing the film, and open the front door after standby off.
m
. Do not open the front door during film running.
If opened, film running will stop instantaneously.
. Never give shocks to the main unit FVS-1000 during film running. Or picture-shifting may occur.
. For the FVS-1000, as the file is run by gearing the perforations of the film with the teeth of the sprock-
et, if the film has been spliced, be sure to open a perforation which suits the standard of the film.
If there is not perforation, the film may be cut during running.
. Be sure to perform STANDBY ON or STANDBY OFF operations at the start or end of film winding.
Supply reel
Film
GR1
GR2
S intermittent
sprocket
S continuous
sprocket
GR5
GR3
Drum for the analog audio
1. Open the front door.
2. Set the supply reel and takeup reel.
3. Pull out the film from the supply reel, then feed it along the path shown in the above figure.
4. Wind the top of the film on the takeup side reel round two or three times.
n
Do not fix the film to the center of the reel with adhesive tape.
If the film is wound automatically, the film may be cut.
5. Close the front door.
6. Operate with the control panel.
2-12
GR4
When install the analog audio
GR5
Drum for the
analog audio
GR4
Takeup reel
GR10
GR9
T intermittent
sprocket
T continuous
sprocket
GR8
GR7
FVS-1000 MMP1
Advertisement
Table of Contents
