Sony FVS-1000 System Maintenance Manual page 165
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
5. Removing the 35 mm head assembly
Remove the audio head flange, and loosen the two set-
screws, and then remove the 35 mm head assembly.
n
Do not loosen the setscrew on the upper side of the audio
head flange.
PRE-46 board
Harness
Set screw
Set screw
Audio head flange
Set screw
6. Removing the audio drum (top)
(1) Release the harness clamp, and disconnect the harness
connector from CN4 on the PRE-46 board.
(2) Remove a screw and washer, and remove the audio
drum (top).
FVS-1000 MMP1
CN3
Harness clamp
35 mm head assembly
3-4. Replacement of Periodic Replacement Part
7. Removing the 16 mm head assembly
(1) Loosen a setscrew, and remove the audio head height
positioning shaft.
(2) Remove the 16 mm head assembly from the audio
head shaft assembly.
n
At this time, the compression spring is removed
together. Be sure not to lose it.
PRE-46 board
Harness
Audio drum
(Top)
Set screw
Washer
PSW3 x 6
Audio head spacer
Audio head hight
positioning shaft
8. Removing the audio drum (bottom)
Remove the audio drum (bottom).
Audio drum (Bottom)
CN4
Harness clamp
Compression
spring
16 mm head assembly
Set screws
3-35
Advertisement
Table of Contents
