Cleaning The Gate Base (35) / (16) Assembly - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
3-2-1. Cleaning the Gate Base (35) / (16)
Assembly
Removal
1. Set a unit in the STANDBY OFF mode.
2. Turn off the power.
3. Release the two one-touch fixing screws with turning
90 degrees counterclockwise, pull the gate base
assembly in the direction of arrow, then remove it
from the guide pin.
One-touch fixing screws
Guide pin
Sprocket
Gate base (35) assembly
FVS-1000 MMP1
Guide pin
Sprocket
4. Remove the adherence with air etc.
5. Clean the top of the gate with the cleaning cloth to
which the cleaning fluid is applied.
6. Wipe the cleaned surface with a dry cloth two or three
times.
Gate base (35) assembly
E guide
Film guide pins
Film guide(G)
Clean
This illustration shows the gate base (35) assembly.
Installation
7. Install the gate base assembly in the reverse order of
removal procedure 1 to 3.
n
When installing, be careful not to hit the gate base
against the sprocket.
[Reference]
When the groove (_) of the one-touch fixing screw is
almost horizontal, the assembly is fixed.
3-2. Cleaning the Running System
Cleaning
Film guide pins
E guide
3-3
Advertisement
Table of Contents
