Sony FVS-1000 System Maintenance Manual page 23
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
(5) Remove the two screws and remove the power supply panel.
(6) Remove the two screws and remove the cord stopper. (Not used when the pipe for power cable is
used.)
(7) Remove the two screws and remove the power supply cover.
(8) Pass a power supply cable through the pipe and fix them to the power supply panel with two nuts.
(9) Remove the cover from the terminal table.
(10)Attach the specified power supply cable to the terminal table as shown in the figure.
(11)Attach the cover to the terminal table.
(12)Fix the power supply panel to the unit with two screws.
Cover
Green head
M6
W
B
G/Y
Power supply code
Terminal table
(13)Attach the power supply cover, RM board bracket, and rear panel to the unit in the reverse order of
above steps.
n
Pull out the power supply cord through the notch of the rear panel.
FVS-1000 MMP1
Code stopper
PSW4 x 8
PSW4 x 8
Power supply
panel
Power supply
cover
PSW4 x 8
Nut
1-10. Installation Procedure
PSW4 x 8
Power supply
panel
Nut
Power supply
cable
Pipe
1-11
Advertisement
Table of Contents
