Replacing The S-Au Assembly - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
4-6. Replacing the S-AU Assembly
4-6. Replacing the S-AU Assembly
Tools
. Torque wrench (For 60 kgf.cm)
. Torque driver bit (For M4 and M5)
Removal
1. Removing the static electricity
eliminator
Remove the static electricity eliminator. (It is not
necessary to remove this part for the serial
number 10701 and later.)
2. Removing the FTP panel B
Remove the FTP panel B.
(Refer to Section 2-7-4.)
3. Removing the S film guide
Remove the two screws, and remove the S film
guide.
4. Removing the S-AU assembly
Remove the four screws, and remove the S-AU
assembly.
Installation
5. Installing the S-AU assembly
Install the S-AU assembly using the four screws.
6. Installing the S film guide
Install the S film guide using the two screws.
7. Installing the FTP panel B
Install the FTP panel removed in step 1.
(Refer to Section 2-7-4.)
8. Installing the static electricity
eliminator
Install the static electricity eliminator. (It is not
necessary to install this part for the serial number
10701 and later.)
4-18
S-AU plate assembly
Screws
5 x 12
W5
Screw
4 x 10
S film guide
Screw 4 x 10
Screws 5 x 12
W5
FVS-1000 MMP1
Advertisement
Table of Contents
