12. Installation of the lenses
(1) Combine the 35 mm conversion lens and the master zoom lens in the following procedure.
There are a standard conversion lens, an aspect conversion lens (anamophics lens, optional accessory
BKFV-410) and an 8P conversion lens (optional accessory BKFV-420) in a 35 mm conversion lens.
n
This procedure is required only when using the above mentioned several 35 mm lens.
1 Remove the protection cap of them.
2 Align the white mark of the master zoom lens and the white point mark of the conversion lens.
Tighten the ring of the conversion lens first before proceeding to tighten the ring of the master
zoom lens.
3 Connect the cable of 35 mm conversion lens with the connector of the master zoom lens.
35 mm conversion lens
Ring
Pin
Cable
Master zoom lens
[Reference]
[Reference]
[Reference]
[Reference]
[Reference]
Removing the Conversion Lens
Loosen the ring of the master zoom lens first before proceeding to loosen the ring of the conversion lens.
. Hold down the ring with full palm of the hand, and then lens will be dismounted easily. (Refer Fig. 1)
. It is too tough to turn the ring with finger head only. (Refer Fig. 2)
Ring
FVS-1000 MMP1
Protection cap
Connector
35 mm 8P Comversion lens
Ring
Cable
Mark
Connector
Master zoom lens
Notch
Fig.1
Fig.2
Mark
1-10. Installation Procedure
Ring
Ring
1-27