Table of Contents
Advertisement
2-4. Film Threading
This unit is designed so that the film cannot be driven unless the front door is closed due to the danger of
touching the film driven with the hand, etc.
For this reason, stop running when removing the film, and open the front door after standby off.
m
. Do not open the front door during film running.
If opened, film running will stop instantaneously.
. For the FVS-1000, as the file is run by gearing the perforations of the film with the teeth of the sprock-
et, if the film has been spliced, be sure to open a perforation which suits the standard of the film.
If there is not perforation, the film may be cut during running.
. Be sure to perform STANDBY ON or STANDBY OFF operations at the start or end of film winding.
For 35mm film
Supply reel
Film
GR1
GR2
S intermittent
sprocket
S continuous
sprocket
GR5
GR3
S film stopper
For 16mm film:
Push up
1. Open the front door.
2. Set the supply reel and takeup reel.
3. Pull out the film from the supply reel, then feed it along the path shown in the above figure.
4. Wind the top of the film on the takeup side reel round two or three times.
n
Do not fix the film to the center of the reel with adhesive tape.
If the film is wound automatically, the film may be cut.
5. Close the front door.
6. Operate with the control panel.
FVS-1000 MMP1
GR4
For 35mm film:
Push down
T continuous
sprocket
GR7
For 16mm film: (T side)
GR6
2-4. Film Threading
Takeup reel
GR10
GR9
T intermittent
sprocket
GR6
GR8
GR8
2-13
Advertisement
Table of Contents
