Ops Assembly Adjustment; Electrical Alignment Overview; Setup Prior To Adjustments - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
6-4. OPS Assembly Adjustment
6-4-1. Electrical Alignment Overview
This adjustment is for matching the OPS glass movement
to the readings taken by the capacitive sensors located in
the gate assembly. When this adjustment is done correctly,
the system will be able to optically position the picture
image to the perforation location even if the film is miss-
parked in the gate. There are two separate glass movement
systems (one for Vertical and the other for Horizontal
position).
Required Tools and Equipment
1. Phillips Screw Driver.
2. Slot Screw Driver of removing gate.
3. Oscilloscope with two probe.
4. Film with curl
5. Film of some length to run for steadiness.
6. Small adjusting tool for RVs on gate and OPS assy.
7. HD Picture Monitor.
8. PC with Hyper Terminal.
9. Connection cable for PC: J-6516-010-A
10. Film stick:
6-4-2. Setup Prior to Adjustments
Prior to making any adjustments of the OPS system, you
must reposition the SV-186 OPS servo board to where the
test points and connection cable for PC are accessible.
A
1
CN501
2
3
S502
TP504
TP510
TP506
4
FVS-1000 MMP1
Cut a 16 mm film in about
5 mm x 30 mm stick
E
B
C
D
CN12
CN100
CN2
TP201
E601
TP202
TP509
TP505
TP514
TP511
TP512
TP507
TP502
TP203
TP205
TP204
TP515
TP206
TP513
TP508
TP207
TP503
1. Turn power off on the system.
2. Remove the top rear back panel from the system.
3. Remove the two screws that is hold the SV-186 board
to the thick metal back plate.
4. Pull-out the SV-186 board along the guide rail.
5. Connect connection cable for PC from PC com1 port
to SV186 board CN501 connector. (Refer to picture
for board lay out.)
Set the PC to Hyper Terminal and set the properties as
follows.
Baud Rate:
38400
Data bits:
8
Parity:
Even
Stop bits:
1
Flow Control: None
F
G
H
CN11
CN21
TP101
TP102
TP311
TP321 TP301
TP601
E731
TP603
TP602 TP604
TP103
TP605
TP105
TP104
TP106
TP107
SV-186 board (A side)
6-4. OPS Assembly Adjustment
SV-186 Board
PSW3 x 6
PSW3 x 6
J
K
L
M
CN1
N
6-7
Advertisement
Table of Contents
