Sony FVS-1000 System Maintenance Manual page 226
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
6-6. Lamp House Adjustment
6-6-3. 16 mm/8P Integrating Sphere
Adjustment
This section describes adjustment methods for the 16 mm
and 8 perforation integrating spheres. This adjustment is as
same as that of 35 mm Integrating Sphere.
16 mm/8P adjustment should be done after 35 mm adjust-
ment.
n
When replacing the integrating sphere of which the LC-35
board's suffix of the lamp house is -12 with the integrating
sphere of the repair parts, it is not neccessary to perform
the adjustment of SE-631 board.
Measuring instruments: Oscilloscope
PC with Hyper Terminal.
Tool:
Connection cable for PC
Preparations
1. Pull out the lamp house.
2. Connect connection cable for PC from PC com1 port
to LC-35 board CN15 connector. (Refer to picture for
board lay out.)
Set the PC to Hyper Terminal and set the properties as
follows.
Baud Rate:
38400
Data bits:
8
Parity:
Even
Stop bits:
1
Flow Control: None
A
B
1
IC463
IC433
RV461
RV431
2
3
TP305 TP303 TP301
4
5
LC-35 board (Suffix -13 and higher, Side A)
6-24
C
D
IC403
RV401
CN15
E
F
FVS-1000 MMP1
Advertisement
Table of Contents
