Sony FVS-1000 System Maintenance Manual page 46
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
1-11. Installation of Optional Units
Rear side
(1) Remove the five screws and remove the duct cover from the rear of the unit. (for UC/CE model only)
(2) Remove the 10 screws and remove the rear shield from the processor assembly. (for UC/CE model
only)
(3) Loosen 2 screws (with stopper) used for the third and fourth slot from the left at the rear, and then
remove the blank panel. (When it is a piece of large blank panel, remove itself.)
Rear shield
(for UC/CE model only)
Screws
Screw
Screws
(4) Insert the DIF-120 board along with the 3rd guide rail from the left.
Use the 3rd and 4th slot for the panel.
(5) Tighten the upper and lower knobs one after the other several times, then insert the connector
completely until the connector is connected.
n
Be sure to tighten the two screws one after the other.
If one screw is tightened completely first, there is a possibility of damaging the connector or screw.
Screw(with stopper)
Screw(with stopper)
1-34
Cover
Screws
Screws
DIF-120 board
FVS-1000 MMP1
Advertisement
Table of Contents
