Replacing The Pad Assembly - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
4-2. Replacing the Pad Assembly
4-2. Replacing the Pad Assembly
Notes
The pad assembly is adjusted for each unit.
Do not install to other FVS-1000s.
When the film is run without adjusting, the film may damage.
To install to other FVS-1000, there is a need to adjust the clearance with the sprock-
et.
35/16S Pad Assembly
Removal
1. Removing the pad assembly
Rotate the two rings of the 35/16S pad assembly
with your fingers in the counterclockwise direc-
tion, and remove the 35/16S pad assembly.
Installation
2. Installing the pad assembly
(1) Align the reference hole and long hole of the
35/16S pad assembly and the pad positioning
shaft.
n
At this time, check that the pad drive pin
enters the pad arm holes.
(2) Press the 35/16S pad assembly against the
base plate, rotate the two rings with your
fingers in the clockwise direction, and install.
4-2
Holes of the padarm
Ring
35/16 S Pad assembly
Reference hole
Pad driving pins
Pad positioning shafts
FVS-1000 MMP1
Advertisement
Table of Contents
