Installation Procedure - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
1-10. Installation Procedure
1. Decision of the place to install
Confirm that the following conditions are satisfied.
. Environmental conditions (Refer to "1-3. Environmental Conditions")
. Installation space (Refer to "1-5. Installation Space")
. Equipments to supply the power and air (Refer to "1-6. Power Supply and Air Supply Specifications")
2. Installation of the main unit
(1) Move the unit to the place to install.
(2) Using the handlifter, etc., lift up the unit until the clearance from the caster to the floor becomes 50
mm.
m
. Use the handlifter of its two claws width is 500 mm or less.
. Insert the claw to the center position between the casters.
. Place a rubber sheet, etc. at the part where the claws and the door of the unit contact.
. When a handlifter is not available, lift up the unit in the following procedure.
1 Place the wooden plates of their thickness are 20 mm under the adjuster feet (four).
2 Turn the adjuster feet with a Phillips screwdriver and lift up the unit.
Claw of the handlifter
FVS-1000 MMP1
Rubber sheet
Claw of the handlifter
Caster
500 mm or less
Screwdriver
1-10. Installation Procedure
Rubber sheet
50 mm
Caster
20 mm
Adjuster foot
1-7
Advertisement
Table of Contents
