Replacing The Power Supply For Processor - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
4-11. Replacing the Power Supply for Processor
Preliminary Preparations
Open the door at the bottom of the unit.
Removal
1. Removing the power supply for the
processor
(1) Turn off the AC power supply which supplies
the power to the FVS-1000.
n
To prevent an electric shock, be sure to turn
off the power of the AC power supply which
supplied the power to the FVS-1000 before
removing.
(2) Remove the four screws.
(3) Holding the handle of the power supply for
the processor, pull out the power supply.
Installation
2. Installing the power supply for the
processor
(1) Align the connector at the rear of the power
supply for the processor and the connector of
the DD-33 board, and push in.
n
Firmly push in the connector at the rear of the
power supply to the connector of the DD-33
board until they connect.
(2) Secure the power supply for the processor
using four screws.
FVS-1000 MMP1
Power supply
connector
Handles
PSW4 x 8
PSW4 x 8
Handles
Power supply
for processor
PSW4 x 8
4-11. Replacing the Power Supply for Processor
4-27
Advertisement
Table of Contents
