Sony FVS-1000 System Maintenance Manual page 21

(9) Turn the adjuster feet with a screwdriver and lower them to the position 5 mm above the floor.
n
Be sure to lower the adjuster feet for safety.
It is recommended to connect the eye-bolts on the top plate and the ceiling with the chains as the fall
preventive measure in an earthquake etc. Give slack a little to the chain at this time.
3. Connection of power supply cord
[WARNING] [WARNING] [WARNING] [WARNING] [WARNING]
When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, so that the
user can turn off the power in case a fault should occur.
[WARNUNG] [WARNUNG] [WARNUNG] [WARNUNG] [WARNUNG]
Beim Einbau des Geräts ist daher im Festkabel ein leicht zugänglicher Unterbrecher einzufügen, damit
sich bei einer Funktionsstörung die Stromversorgung zum Gerät jederzeit unterbrechen läßt.
[AVERTISSEMENT] [AVERTISSEMENT] [AVERTISSEMENT] [AVERTISSEMENT] [AVERTISSEMENT]
Lors de l'installation, incorporez un interrupteur dans le fil électrique, fixé près de l'appareil, pour qu'on
puisse couper l'alimentation en cas d'anomalie.
m
. Use the specified power supply cord.
If the power supply cord other than the specified one is used, there is a danger of a fire or an electrical shock.
. This work may be required by laws of each country. Follow laws of each country.
Specified power supply cord
. 600 V VCT cable (3 cores)
Select from the following three cords according to the power consumption.
Size (cross section area)
2
5.5 mm : 36 A or less
2
8.0 mm : 44 A or less
2
14.0 mm : 62 A or less
. Wire crimp type terminal
17 mm 6.73 mm
FVS-1000 MMP1
Chains
Size (cross section area)
Wire crimp type terminal
1-10. Installation Procedure
VCT cable
1-9