Installing Lens Pieces; Figure 45 Installing A Lens Piece On The Handpiece - Clarity RetCam3 User Manual

Installing Lens Pieces

Figure 45 Installing a Lens Piece on the Handpiece

Alignment pins
on handpiece
Attach the desired lens piece to the Handpiece, as shown in
• Fit the lens piece on the handpiece, aligning the 3 radial pins on the front of the
• Twist the lens piece clockwise (as shown in
RetCam 3 and RetCam Shuttle User Manual
Align lens
piece to fit
over pins
Carefully inspect and clean the lens piece before each use. DO NOT use if
the lens piece has nicks, breaks, scratches, or rough surfaces that can
damage the eye.
handpiece with the spaces between the tabs of the spring ring on the lens piece.
click, indicating that the lens piece is locked in place.
To mitigate the potential for excess light exposure to the patient during
imaging, always start at the lowest light intensity level and increase if
necessary. Use only the shortest exposure time necessary; no longer than 5
minutes per eye.
NOTE
When the handpiece is not in use, store it in the cart or on the holster.
Preparing the System for Use
Carefully tighten
clockwise until it clicks in
place.
Figure 45 on page
Figure 45 on page 71) until you hear a
PN 18-000393 Rev. A
71
71.