Installing Lens Pieces
Figure 36 Installing a Lens Piece on the Handpiece
Alignment pins
on handpiece
Attach the desired lens piece to the Handpiece, as shown in
• Fit the lens piece on the handpiece, aligning the 3 radial pins on the front of the
• Twist the lens piece clockwise (as shown in
Handpiece Connection
Verify that the handpiece is connected to the system as shown in
RetCam 3 and RetCam Shuttle User Manual
Align lens
piece to fit
over pins
Carefully inspect and clean the lens piece before each use. DO NOT use if
the lens piece has nicks, breaks, scratches, or rough surfaces that can
damage the eye.
handpiece with the spaces between the tabs of the spring ring on the lens piece.
click, indicating that the lens piece is locked in place.
Preparing the System for Use
Carefully tighten
clockwise until it clicks in
place.
Figure 36 on page
Figure 36 on page
65) until you hear a
Figure 37 on page
PN 18-000393 Rev. A
65
65.
66.