64
Chapter 4
Preparing the RetCam 3 System for Use
Turning the System ON
1. Turn the main power switch, located on the rear of the system, to ON.
2. Carefully pull out the keyboard tray until it is fully extended.
The membrane control panel is located at the front of the keyboard tray. It provides
controls and indicators of system status
3. Depress the System Power button (located on the Control Panel) to turn ON system
power. This action illuminates the System Power indicator light (solid green) and
initializes the software.
Figure 34 Control Panel
System Power
indicator
(green)
System Power
button
Figure 35 Footswitch Controls
RetCam 3 and RetCam Shuttle User Manual
AC/DC
indicator
(green)
Focus
Focus Controls
(Figure 34 on page
Relative intensity
indicator
Intensity Controls
Snap
(capture)
button
Focus Controls
Illumination intensity controls
Snap toggle switch
(start or pause video capture or
single image capture)
Preparing the System for Use
64).
Illumination ON
indicator (amber)
Lamp Illumination
PN 18-000393 Rev. A