158
Chapter 12
Figure 149 Front Panel Showing Lamp Assembly Drawer
.
7. Grip the handle on the lamp assembly drawer
drawer out slowly. Stop when the light bulb is fully exposed.
8. Just behind the socket and extending from the rear of the illumination lamp is a thick
grey lever, the "lamp ejector" (shown in
or catch, the illumination lamp unit as you gently rotate this lever toward you (rotate it
up, or counterclockwise to eject the lamp). Remove the old illumination lamp.
Figure 150 Removing the Illumination Lamp
.
RetCam 3 and RetCam Shuttle User Manual
Maintenance and Support
Remove 2 screws
Lamp assembly drawer
Lamp assembly drawer handle
(Figure 149 on page
Figure 150 on page
158). Be prepared to grab,
Lamp Ejector
158). Pull the
PN 18-000393 Rev. A