Figure 158 Eject The Bulb - Clarity RetCam3 User Manual

or catch the illumination lamp unit as you gently rotate this lever toward you (rotate it
up, or counterclockwise to eject the lamp). Remove the old illumination lamp.

Figure 158 Eject the Bulb

7. Carefully slide the bulb out of the socket slots.
8. Catch the bulb.
RetCam 3 and RetCam Shuttle User Manual
Touch only the exterior surface of the illumination lamp. Do not touch the
bulb, which is located in the center of the reflector, nor the inner (concave)
surface of the reflector. Skin oils adhere to the bulb and reflector, which
reduces the cooling efficiency of the bulb and thereby creates a hot spot that
leads to premature burnout. Handle the outside of the lamp only, as shown in
Figure 159 on page 164
Maintenance and Support
Lamp ejector
and Figure 160 on page 164.
PN 18-000393 Rev. A
163