Figure 15 Utilities Menu; Figure 16 User Preferences Window - Clarity RetCam3 User Manual

46 Chapter 2
To configure the RetCam 3 or RetCam Shuttle for use with RCRS, select the "gear" icon
Preferences.

Figure 15 Utilities Menu

When the User Preferences window appears, select Synchronization to display the
options for RCRS.

Figure 16 User Preferences Window

Check the Enable Synchronization checkbox, and enter the name or IP address of the
server that is running the RCRS. Click
been established with the RCRS server.
RetCam 3 and RetCam Shuttle User Manual
NOTE
Prior to performing this step, establish a physical connection to the network
used to support RCRS by plugging a shielded RJ-45-equipped Cat5 or Cat6
cable into the network connector on the RetCam system (on the rear of the
RetCam 3 cart or on the notebook computer of the RetCam Shuttle).
on the bottom right of the screen to display the Utilities menu, and then select User
NOTE
The Server Name field does not require that you enter http://www or
https://www.
RetCam System Software Configuration
to verify that communication has
PN 18-000393 Rev. A