Preparing The Retcam Shuttle System For Use; Turning The System On; Power Cord And Power Connector; Figure 41 Main Power Switch - Clarity RetCam3 User Manual

68 Chapter 4

Preparing the RetCam Shuttle System for Use

Turning the System ON

Power Cord and Power Connector

The main power switch is located above the power cord inlet. It must be in the ON position
to operate the system.

Figure 41 Main Power Switch

RetCam 3 and RetCam Shuttle User Manual
NOTE
Place components and cabling in a manner to prevent hazards to users or
equipment.
NOTE
Do not switch OFF or disconnect main power during imaging; doing so might
cause data corruption.
On Off
Switch shown off
Preparing the System for Use
PN 18-000393 Rev. A