164
Chapter 12
Figure 159 Catch the Bulb
9. Holding the new lamp only on the outside, align the two pins in the rear with the
corresponding tracks in the socket ensuring the alignment bumps on the lamp is
aligned with the notch in the lamp bracket and push it gently and evenly into place.
Figure 160 Insert New Bulb
10.Check the position of the new bulb to make sure that the reflector of the bulb is located
in the center of the lamp socket opening.
11. Carefully push the lamp assembly drawer back. Use caution to avoid pinching wires in
the area.
12.Replace the two screws on the lamp assembly drawer and replace the fiber optic
cable.
RetCam 3 and RetCam Shuttle User Manual
Maintenance and Support
PN 18-000393 Rev. A