To Transport The System To Another Location; Figure 14 Transporting The Shuttle - Clarity RetCam3 User Manual

34 Chapter 1

To transport the system to another location:

1. Power down the system through the software by selecting
2. Switch OFF mains power on the back of the unit. Unplug the power cord from the wall
outlet and drape it over the transport handle or store the power cord inside the cart.
3. Carefully remove the lens and store it in the lens box. Secure the handpiece and
footswitch in their storage compartments in the cart.
4. Remove the notebook computer from the work surface and carry it separately.
5. Close the cart doors. Unlock the caster brakes.
6. Extend the transport handle upward and use it to tilt the cart and roll it to a vehicle for
transport.
Inside the vehicle, we recommend placing the RetCam Shuttle front side up.

Figure 14 Transporting the Shuttle

RetCam 3 and RetCam Shuttle User Manual
Introduction
and then Shutdown.
PN 18-000393 Rev. A