32
Chapter 1
Introduction
The Handpiece Focus connector is a direct insert receptacle for insertion of the (white)
focus motor cable, which is part of the handpiece interconnect harness.
To insert the cable, align the red dot on the connector with the red dot on the Focus port
and insert. To detach, pull back on the connector, being careful not to pull on the cable.
The focus connector is not threaded!
The Camera Handpiece connector is a receptacle for insertion of the black camera
controller cable, which is part of the handpiece interconnect harness.
To insert the camera handpiece connector, align the notch on the inside connector
(Figure 11 on page
32) with the notch on the EO box
(Figure 12 on page
32), insert, and
tighten screw to secure. To detach, unscrew (counterclockwise) the connector sleeve and
pull out.
Figure 11 Inside Connector Notch
Figure 12 EO Box Notch
RetCam 3 and RetCam Shuttle User Manual
PN 18-000393 Rev. A