Memory Card → Converter - Siemens SINAMICS G115D Operating Instructions Manual
Distributed drive
Hide thumbs
Also See for SINAMICS G115D:
- Operating instructions manual (552 pages) ,
- Operating instructions manual (600 pages)
Table of Contents
Advertisement
7.1.3
Memory card → converter
You can transfer parameter settings from a memory card to the converter by the following
methods:
• Automatic transfer
• Transfer with Startdrive
Automatic transfer
Precondition
The converter power supply has been switched off.
Procedure
1. Insert the memory card into the memory card slot.
2. Switch on the converter power supply.
If there is valid parameter data on the memory card, the converter accepts the data from the
memory card.
❒
Transferring using Startdrive
Precondition
• A memory card is inserted in the converter.
• Connection between the PG/PC and converter has been properly established via a USB
cable or the fieldbus.
• You have installed the Startdrive commissioning tool on your PG/PC.
Procedure
1. Go online.
2. Proceed as follows to transfer parameter settings from the memory card to the converter.
3. Wait until Startdrive has signaled that the data transfer has been completed.
Note
After the transferring process has completed, safely remove the memory card.
You have transferred your settings from a memory card to the converter.
❒
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Data backup and series commissioning
7.1 Transferring settings using a memory card
285
Advertisement
Table of Contents
