Tools Required; Removing Transport Rails; Screwing The Transport Units Together - Siemens SINAMICS SM150 6SL3815-7NP41-0AA1 Operating Instructions & Installation Instructions

Installation

5.4 Screwing the transport units together

5.2

Tools required

You require the following tools for mounting and installation:
● Wrench or socket wrench, width across the flats 10, 13, 16/17, 18/19
● Allen key, size 8
● Torque wrench up to 50 Nm
● Screwdriver, size 2
● Torx T20 and T30 screwdrivers
5.3

Removing transport rails

Support rails for crane transportation are attached to the bottom of the cabinet.
To remove the rails, remove the fixing screws
Figure 5-1
5.4 Screwing the transport units together
NOTICE
Material damage caused by mechanical pressure on components
Stress that occurs during transport may exert mechanical pressure on the components.
Material damage can result.
● Line the cabinets up precisely with each other in order to avoid shearing forces when the
● Install the converter only on a level and horizontal surface.
88
Removing the support rails
base units are screwed together.
①
with an M12 spanner.
SINAMICS SM150 6SL3815-7NP41-0AA1
Operating Instructions Rev.201910281301 EXAMPLE