Up/Down Buttons; Rig Buttons; Tap Button - Kemper Profiler Main Manual

Front Panel Controls Stage 55
The "Gain" parameter always compensates for loss in level, no matter how much you reduce it by. You can turn the
gain value to zero for every Amp PROFILE, and the result will be a totally undistorted and uncompressed sound that
has the same perceived loudness as the fully distorted version.

Up/Down Buttons (20)

In Performance Mode, use these buttons to navigate through your Performances. A short tap will step up or down to
the next Performance. Holding will initiate scrolling. Depending on the status of the parameter "Performance Load" in
the System Settings, the PROFILER will either load Slot 1 or the current Slot of the selected Performance
immediately, or wait ("Pending") until you hit one of the five
Rig Buttons.
In Browser Mode, you can step or scroll through Rigs in your browse pool according to the selected View and
Sorting. The option "Group of 5/Single Rig" on page
Remote Settings in System Settings determines, if the Up/Down
Buttons step through the Rigs individually or by groups of five in Browser Mode.

Rig Buttons 1-5 (21)

These are the buttons for selecting Slots in Performance Mode, and Rigs in Browser Mode influenced by the
selected View and Sorting. Subsequent hits of these buttons trigger Morphing.

TAP Button (22)

This button triggers the Tap Tempo, just like the TAP button on the front panel of the PROFILER. Tap in quarter
notes to adjust the tempo of delay, phaser, flanger, and tremolo effects. The LED will blink to indicate the current