Direct Output/Send; Return And Alternative Input - Kemper Profiler Main Manual

DIRECT OUTPUT/SEND (3)

This carries the direct output signal in glorious mono. The main purpose for this output is to feed signals into the
reference amp during PROFILING
OUTPUT/SEND in combination with the
OUTPUT/SEND becomes a mono send. If you're not using this output as part of an effects loop, it will normally carry
the original guitar signal. So, if you want to record your guitar dry, either connect the DIRECT OUTPUT to the
recording device, or to the input of your audio interface.
✓
The functions described in the above paragraph are only the standard settings. You can change the signal sources
individually for each output in the Output Section; e.g. you can set the
and reverb signal, while the DIRECT OUTPUT carries the pure amp sound without effects. There is also a tutorial
video specifically about Output and setup for recording available on:

RETURN and ALTERNATIVE INPUT (4)

The ALTERNATIVE INPUT can be used as a rear-side guitar input, which is especially convenient for the Rack, and
PowerRack models. The parameter
The RETURN is available as balanced TRS or XLR input. While it plays a key role during PROFILING
explained in the chapter Taking a
loop in external equipment. In combination, RETURN and ALTERNATIVE INPUT can function as a pair of stereo
returns. Details can be found in the
Both the RETURN and the ALTERNATIVE INPUT can also be used as
this feature to mix in music from your mp3-player and play along. In this case you will need a special cable with 3.5
mm stereo jack on one side and two ¼ inch mono jacks on the other side. You will find the corresponding mix
controls in the Output Section.
✓
Please note that the XLR input does not provide phantom power.
Back Panel Overview Head, PowerHead, Rack, and PowerRack 41
TM
. This is not its only purpose, however: you can also use the DIRECT
RETURN input to create an
"Input Source"
needs to be set accordingly in the Input Section.
PROFILE, it can also be used in combination with the DIRECT OUTPUT/SEND to
Effect Loops chapter.
effects loop. In this case, the DIRECT
MAIN OUTPUT to only deliver the wet
www.kemper-amps.com/video
auxiliary inputs. You could, for instance, use
delay
TM
, as