Clear Effect; Autoload - Kemper Profiler Main Manual

Rigs and Signal Chain 23
boundaries of the previously selected type — once you reach the end of the relevant presets, you will find the entire
preset collection at your fingertips.
Use the soft button "<- Category/-> Type" to toggle the function of the knob. If "<- Category" is selected, you
TYPE
can scroll the list in the left-hand column by category.
Jumping through the effect categories like this, rather than by type, will allow you to navigate very quickly through a
large collection of effect presets.
You could think of the Effect Select Screen as being like the hands of a clock, with hours, minutes and seconds, i.e.,
changing the category will move the type and preset column as well. On the other hand, if you browse through the
effect presets, the types and categories will also follow, as the presets cross the respective boundaries.

Clear Effect

To clear an effect module, simply scroll to the top of the list by either category, type or preset and load the item
"empty".

Autoload

Usually, presets are loaded automatically whenever you scroll the list with the BROWSE knob. This feature is called
"Autoload" and is active by default. If you would prefer this not to happen, then untick the "Autoload" box with the
button. This leaves you free to scroll at your preferred rate, but you will need to press "Load
corresponding soft
Preset" whenever you wish to audition one. PROFILER Stage™ users can push the BROWSE knob to load a preset
instead. The box to reactivate Autoload is always available on the Effect Select Screen.
As soon as the Effect Select Screen is left and the selected effect is in focus use the <PAGE> buttons to navigate
through the pages with effect parameters.
Incidentally, the same principle of "autoload vs manual load" applies to browsing Rigs with the BROWSE knob.