Send 1+2; Main Output - Kemper Profiler Main Manual

Back Panel Overview Stage 59
RETURN inputs can also be used in combination with SEND outputs to loop in external mono or stereo equipment.
Details can be found in the Effect Loops chapter.
RETURN 1 and 2 can also be used as auxiliary inputs. You could, for instance, use this feature to mix in music from
your mp3-player and play along. In this case you will need a special cable with 3.5 mm stereo jack on one side and
two ¼ inch mono jacks on the other side. You will find the corresponding mix controls in the Output Section.

SEND 1+2 (3)

SEND 1 carries the direct output signal in glorious mono. The main purpose for this output is to feed signals into the
TM
reference amp during PROFILING . This is not its only purpose, however: you can also use SEND outputs in
combination with the four RETURN inputs to create effects loops. In this case, a SEND becomes a mono send.
If you're not using SEND 1 as part of an effects loop, it will normally carry the original guitar signal. So, if you want to
record your guitar dry, either connect the SEND 1 to the recording device, or to the input of your audio interface.

MAIN OUTPUT (4)

These are your main stereo outputs. Use these outputs to connect to a mixing desk in a recording studio, or to the
front-of-house mixer in a live situation. These outputs deliver the entire Rig: Amp, Cabinet, and all Effects. You have
a choice of XLR (balanced) or quarter-inch TS-jacks (unbalanced). The XLR outputs are protected against 48V
phantom power fed by a mixing desk. However, you should avoid feeding phantom power into the PROFILER if you
want the best audio quality. Like all inputs and outputs, it offers a ground lift in the menu of the Output Section to
prevent a loop hum.