Tap Button; System Button; Rig Button - Kemper Profiler Main Manual

Front Panel Controls Head, PowerHead, Rack, and PowerRack 32
Master Volume maintains the relative volume settings of all outputs linked to it. For example, if MONITOR OUTPUT
Volume is set relatively low and Main Output Volume relatively high, and both are linked to Master Volume, you
might need to crank up Master Volume quite a bit before the MONITOR OUTPUT will send a signal. In an extreme
case, one output could still be dead even with Master Volume at maximum. Please use the individual volume
controls in the Output Section to balance their levels according to your needs. As a rule, it's best to avoid extreme
volume differences between any of the outputs linked to Master Volume.
As output volumes of linked outputs might vary, Master Volume doesn't follow a dB scale, but a simple 0-10 scale.

TAP Button (8)

This button triggers Tap Tempo. The PROFILER Remote™ offers another TAP button for foot control. Hold it down
to activate Beat Scanner.

SYSTEM Button (9)

This button opens System Settings which contain multiple pages of global parameters. Global settings are not stored
by Rig, so they remain unchanged when you load different Rigs or Performances.

RIG Button (10)

The RIG button opens Rig Settings with contain multiple pages of settings that are stored and recalled with each Rig.