Output Led; Master Volume Knob - Kemper Profiler Main Manual

Front Panel Controls Stage 49

OUTPUT LED (5)

The PROFILER performs soft clipping and is very forgiving in terms of amplitude clipping, so here is no need to
panic if the OUTPUT LED flashes red occasionally. Typically, you might experience this with clean sounds. In such
cases you could either decrease Rig Volume or another Volume in the Rig e.g. Amplifier Volume, or perhaps
consider enhancing your clean Rig with a Compressor effect.

MASTER VOLUME Knob (6)

Master Volume is the master of all output volumes and is always global. It is not stored as part of any Rig. Changing
the volume will not affect the color of the sound.
Volumes of all analog outputs including the HEADPHONE output are linked to Master Volume by default. These links
(e.g. "Headphone Link").
can be activated and deactivated with soft buttons in the Output Section
Master Volume maintains the relative volume settings of all outputs linked to it. For example, if MONITOR OUTPUT
Volume is set relatively low and Main Output Volume relatively high, and both are linked to Master Volume, you
might need to crank up Master Volume quite a bit before the MONITOR OUTPUT will send a signal. In an extreme
case, one output could still be dead even with Master Volume at maximum. Please use the individual volume
controls in the Output Section to balance their levels according to your needs. As a rule, it's best to avoid extreme
volume differences between any of the outputs linked to Master Volume.
As output volumes of linked outputs might vary, Master Volume doesn't follow a dB scale, but a simple 0-10 scale.
MASTER VOLUME offers a LED collar, which reflects the volume of one output. You can select this output in
with "Volume LED Collar".
System Settings