Rig Change In Browser Mode - Kemper Profiler Main Manual

4 Performance 77 Slot 5 - Performance 103 Slot 2
5 Performance 103 Slot 3 - Performance 125 Slot 5
Instead of calculating the appropriate MIDI bank select, LSB and program change, you could simply read it from the
screen. If no PROFILER Remote is connected, both items are displayed for the current Slot on the left-hand side of
the home screen in Performance Mode.
While program changes are required to initiate the Rig load, bank select MSB and LSB are redundant. You don't
need to send bank select MSB because Performance Mode always assumes value "0". Bank select LSB is not
required if you navigate within the same MIDI bank.
These two MIDI control change numbers are associated with MIDI bank select:
#0 Bank select MSB (always value 0)
#32 Bank select LSB (values 0-4)

Rig Change in Browser Mode

You can assign up to 128 MIDI program change numbers to Rigs in your browse pool. These assignments are set in
the System Settings on page "Browser Mode PrgChg".
To assign a program change number to a Rig, first load the Rig in the Browser Mode. Then press the
button. Navigate to the page "Browser Mode PrgChg" using the PAGE buttons.
Select a desired program change number using soft knob "MIDI PrgChg#" and then press the soft button "Assign".
Use the soft button labeled "Unassign" to erase assignments.
3 (#Performance - 77) * 5 + (#Slot - 5)
4 (#Performance - 103) * 5 + (#Slot - 3)
MIDI 274
SYSTEM