Dly And Rev Modules - Kemper Profiler Main Manual


•Brass
In addition to the string-like effect of the crystal pitch shifters, the "Brass" parameter allows you to bring some
nonlinearities to the reverb structure, giving it a brasher sound, more like that of a brass section.
✓
Example setup: For a reverb that plays exclusively one octave higher than the input signal without building up, set
Pitch Mix all to the right, both Pitches to +12, and Pitch Buildup to zero.

DLY and REV Modules

As they appear last in the effect row, the DLY and REV modules have special properties. Both can hold any kind of
effect type, but when the DLY module contains a delay effect, and the REV module a reverb effect, these special
properties become apparent:
Firstly, you can make use of the dedicated control knobs for the Mix and Feedback / Decay Time settings, found on
the PROFILER Head and Rack. However, as well as this:
•
Both modules offer a spillover for delay and reverb tails. That means, the effect tails are not cut when you switch to
the next Rig.
•
The delay and reverb tails can be tapped separately by a dedicated analog or digital output, for creating a so-called
wet-dry-wet configuration.
Read more about wet-dry-wet in the Output Sources chapter.
Reverb (Green) 230