Tremolo / Auto Panner - Kemper Profiler Main Manual

Tremolo / Auto Panner

The Tremolo modulates the level of the signal in a periodic manner.

Rate
Use the "Rate" soft knob to adjust the speed of Tremolo modulation; this parameter is almost continuously variable
but stays in sync to the actual tempo of the Rig. The tempo can be dialed in manually or tapped on the
When "Tempo" is engaged, the rate will be displayed in musical values. Please refer to the
information about the tempo sources and settings.

Depth
Use the "Depth" parameter to adjust the intensity of the modulation.

Crossover
Use the "Crossover" parameter to blend out the tremolo effect for the lower frequencies of the signal.
✓
When you place the Tremolo after the stack, where stereo signals can be created, it becomes a stereo panorama
effect ("Auto Panner"). The intensity and character of the stereo effect can be controlled by the "Stereo" parameter;
this determines the phase offset of the independent level modulations for the left and right sides. When you set
"Stereo" to the middle position (zero value), both sides will be in phase, thereby creating a mono tremolo effect.
Chorus (Blue) 179
TAP button.
Tempo chapter for more