Cabling - Kemper Profiler Main Manual
Hide thumbs
Also See for Profiler:
- Main manual (246 pages) ,
- The basics & profiling manual (144 pages) ,
- Quick start manual (132 pages)
Table of Contents
Advertisement
PROFILER Remote 264
Cabling
The PROFILER and PROFILER Remote communicate with each other via an ethernet cable. The cable included in
the PROFILER Remote package with its Neutrik® etherCON® cable connector carrier has been carefully selected
and is perfectly suited for this purpose. If you decide to use any 3rd party cable, please make sure it meets our
quality standards.
The diameter of the wire is the critical factor. The cable delivered with the Remote meets American Wire Gauge 24
(AWG), which can support up to 7.5m (22ft) length. AWG 26 cables have a smaller diameter and can only support
up to 5m (15ft). Cables with higher AWG e.g. AWG 28 should not be used with the Remote.
Cables in excess of 10m (30ft) might require a Power over Ethernet Injector (PoE Injector).
Cabling with PoE injector close to PROFILER
This will enable you to bridge distances of more than 100m (300ft). The PoE injector can be located close to the
PROFILER e.g. in the same rack and connected via a short ethernet cable.
Advertisement
Table of Contents
