Input Led; Module And Section Buttons - Kemper Profiler Main Manual

INPUT LED (2)

The LED reflects the level of the input signal. Its base color can be changed from green to blue with the option
LEDs Blue in System Settings.

Module and Section Buttons (3)

These buttons are associated with the modules and section of the signal chain as described in the chapter
Signal Chain before. A short press will switch the associated module or section on and off. Press longer to open the
associated menu. Once inside a menu use the
OUTPUT/MASTER Button (4)
This button brings the settings of the Output Section into focus. These are:
•
volume settings for different outputs
•
Volume Link soft buttons to link and unlink the individual volumes to the
•
Output Sources to feed the outputs with different signals
•
separate Main Equalizer and Monitor Equalizer
"Monitor Cab Off", a global switch to bypass the virtual speaker cabinet individually for the MONITOR OUTPUT and
•
consequently for the built-in power amplifier
"Monitor Cab Off"
By engaging
on stage, while the MAIN OUTPUT still carry the full signal, including the virtual speaker, which would be connected
to the front mixing desk.
Front Panel Controls Head, PowerHead, Rack, and PowerRack 29
PAGE buttons
of the PROFILER PowerHead
you can run the PROFILER directly to a power amp driving a physical guitar cabinet
to scroll through pages of parameters.
MASTER VOLUME knob
TM
and PROFILER PowerRack
Signal
Rigs and
TM
models