Workflow - Kemper Profiler Main Manual

Workflow

An example of how you would normally work with the Looper:
Button used Task performed
LOOPER Activate the Looper mode for the six Looper Buttons, by pressing the LOOPER button on the
PROFILER Remote. The LOOPER LED lights up. When you press Looper again, the six buttons
will revert to their primary function for selecting Rigs. Activating the Looper Mode does not
necessarily mean activating the Looper itself. The Looper can even stay active while you use the
respective buttons for selecting Rigs.
You start the initial recording by pressing this button. By pressing it the second time, you set the
loop end, and the Looper will immediately stop the recording, and start to playback the recorded
loop from the beginning, and repeat it indefinitely. The timing of both hits on the button is crucial
for the accurate groove of the loop. During the playback, you can play along the loop without
recording anything.
When you hit the button again at any time, the overdub starts without interrupting the playback.
Everything you play will be added to the previous recording. Pressing the button another time will
stop the overdub, and continue the pure playback again.
Note: the initial recording of a loop and the setting of the loop end is only done once. Changing
from playback to overdub, and back to playback, can be done to eternity.
Note: this function can also be assigned to external switches or for example the Remote's
TUNER button, if you are used to trigger
require TUNER button in its default functionality.
Stops the playback of the loop. To restart the playback, press "Record / Playback / Overdub". To
go from stop to overdub, you must press "Record / Playback / Overdub" a second time. To erase
the current loop and start a fresh initial recording, press "Stop" three times. Then press "Record /
Playback / Overdub" to record.
Note: this function can also be assigned to external switches or for example the Remote's
TUNER button, if you are used to trigger
require TUNER button in its default functionality.
Tuner Mode via Volume Pedal
via Volume Pedal and therefore don't
Tuner Mode
PROFILER Remote 260
and therefore don't