Effect Presets; Effect Select Screen - Kemper Profiler Main Manual

Rigs and Signal Chain 22
If you intend to use a modulation effect in your Rig, we recommend placing it in the MOD module, as both the
TM
PROFILER Head and PROFILER PowerHead provide two additional knobs for controlling the Rate and Intensity
parameters.
All PROFILER variants offer these same parameters within their delay, reverb and modulation effects.

Effect Presets

With an effect module in focus on the display, rotate the BROWSE knob to open the Effect Select Screen and select
effect presets from the list in the right-hand column. Effect presets contain an effect type along with custom settings
for all its parameters. These presets are treated as user data, and can be freely stored or overwritten, in the exact
same way you would handle a Rig or Performance.
Each PROFILER comes with a set of factory presets preinstalled. These can be excellent starting points when you
intend to configure a specific effect setting - just find a preset that comes close and then fine-tune its parameters to
your needs.
Presets allow you to store your preferred Rig building blocks under a name of your choice, so your favorite wah,
booster, delay, etc., can be immediately available for you to use in any Rig.

Effect Select Screen

The Effect Select Screen can be opened with both the TYPE knob or the BROWSE knob, whenever an effect
module is open.
The column on the left of the display shows the available effect categories, with the current selection always
displayed in the center position. Each effect category also contains multiple effect types; these are displayed in the
middle column, with the currently selected type in the center.
By further rotating the TYPE knob, you can select another effect type. In doing so, you will notice that the preset
column on the right-hand side will change to reflect the selected effect type. Turn the BROWSE knob to the right to
step through and audition the presets associated with this type. You are always free to browse beyond the