On/Off Button; Mode Select Buttons; Input Button - Kemper Profiler Main Manual

On/Off Button (1)

Use the On/Off Button to switch the PROFILER Stage on and off.
If you use this button to power off before disconnecting the power cable, the Stage will remain in standby as soon as
you reconnect it to a power source. If you disconnect the power while the unit is still active, either by switching off a
power distributor, pulling the plug, or in the case of a general power outage, the Stage will automatically restart as
soon as a power source is reconnected.

Mode Select Buttons (2)

You can select one of the following modes:
Browser Mode Here you can browse through your Rig pool stored in the PROFILER.
Performance Mode Here you can organize your sounds for live performances. A chapter of this manual is
dedicated to
PROFILER Mode Hold both buttons to enter PROFILER Mode and create your own PROFILEs. Details can
be found in chapter

INPUT Button (3)

Press this button to enter the Input Section. Here, you can set the input sensitivity and select the physical input for
your guitar signal. In Browser Mode, the Input Section is locked by default. This means that the settings will be
Performance Mode.
PROFILING an Amp.
Front Panel Controls Stage 45