5
Simulation
5.6 Three-dimensional display
5.6.2 Cutting a section out of the workpiece
Shifting section planes
5-338
You can cut a section out of the volume module to obtain certain
views.
Precondition: You have selected one side of the workpiece.
Select the "Cut open" softkey.
To make concealed contours visible, shift the section planes using the
cursor and "Paging" keys (see also Sec. "Representation in 3-plane
view") to any position.
The new setting is displayed after a short update time.
Example of a section through a volume model:
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
5
10.04
Siemens AG, 2004. All rights reserved