Starting/Stopping The Quick Display For Mold Making; Views In The Quick Display - Siemens SINUMERIK 840D Operation/Programming Manual

5
10.04
5.7

Starting/stopping the quick display for mold making

Starting simulation
Precondition
Mold Mak.
G1 Blocks
...
Progress display
Ending simulation
End
5.8

Views in the quick display

Selecting the 3D view
Selecting 2D views
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition

5.7 Starting/stopping the quick display for mold making

A part program is selected in the Program Manager.
Press the "Simulation" and "Mold Making G1 Blocks" softkeys.
The program is shown in a two-line portion of the work window
header. The first program block is highlighted.
Construction of the workpiece graphics starts.
A message line below the visualized workpiece shows the percentage
of the total program that is already shown in the graphics.
Press the "End" softkey.
This takes you back to the Program Manager.
Changing operating areas interrupts graphics construction. If you
return to the Program Manager operating area, it is resumed.
You can switch between the 2D- and 3D-views at any time. In the
selected view, you can rotate the workpiece in any direction.
Press the "3D-View" softkey.
Press the "X/Y-View" softkey.
- OR -
Press the "X/Z-View" softkey.
- OR -
Press the "Y/Z-View" softkey.
The workpiece is visualized in the selected view.
5
Simulation
5-339