Correcting A Program - Siemens SINUMERIK 840D Operation/Programming Manual

2
Operation
2.11 Trial program run

2.11.3 Correcting a program

Continuing machining
2-134
As soon as the control detects a syntax error in the program, it
interrupts the program and displays the syntax error in the alarm line.
If an error occurs (Stop state), you can edit the program in the
program editor.
Select a program in "Machine Auto" mode.
The program status must be either "Stopped" or "Reset".
Press the "Prog. corr." softkey.
The program editor opens.
If an error has occurred, the errored block is marked. Press the "Input"
key and then correct the block.
Press the "Accept" softkey to transfer the correction to the current
program.
Press the "Execute" softkey followed by the "Cycle Start" key.
Cycle Start
Execution of the program is continued.
• Cycle Stop status:
You can only modify blocks that have not yet been executed or
read in by the NC.
• Reset status:
All blocks can be edited.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
 Siemens AG, 2004. All rights reserved