Siemens SINUMERIK 840D Operation/Programming Manual page 410

8
Alarms and Messages
8.2 Alarms in ShopMill
112330
Explanation
Response
Remedy
112340
Explanation
Response
Remedy
112350
Explanation
Response
Remedy
112360
Explanation
Response
Remedy
112400
Explanation
Response
Remedy
112401
Explanation
Response
Remedy
112402
Explanation
Response
Remedy
8-410
Set swivel table
The operator is prompted to set the swivel table in accordance with
the specified data.
Alarm display
Please refer to the machine manufacturer's instructions.
Set swivel table.
Please refer to the machine manufacturer's instructions.
Confirmation not possible because axes are not referenced!
User confirmation in Safety Integrated cannot be given until the
reference point has been approached.
Alarm display
Approach reference point.
No swiveling data available
No swiveling data sets are available.
Alarm display
Set up the necessary swiveling data sets
(see /FBSP/, ShopMill Description of Functions)
Step was not included in program chain because program is
running
The program that you want to change is currently being executed in
"Machine Auto" mode. You cannot change programs when they are
being executed in "Machine Auto" mode.
Alarm display
End program execution in "Machine Auto" mode.
Does not exist in tool management
The tool specified in the program does not exist.
Alarm display
The tool must be created before the data backup.
Could not create tool
A tool could not be created when reading in tool data.
Alarm display
Check the tool management system.
Work offsets: Error when writing
Data was not written into the work offset.
Alarm display
Check work offset.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved