2
Operation
2.10 Automatic mode
Cycle Start
Program.
stop
Skipping G code blocks
Skip
Cycle Start
Skip
Allowing DRF offset
DRF
offset
Cycle Start
DRF
offset
2-126
Press the "Cycle Start" key again each time.
Execution of the program is continued.
Press the "Program. stop" softkey again if you want the program
to be executed without a programmed stop. (The softkey is
deactivated again.)
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Prog. Cntrl." softkey.
Press the "Skip" softkey.
Press the "Cycle Start" key.
Execution of the program starts. G code blocks with the "/" character
(slash) in front of the block number are not executed.
Press the "Skip" softkey again if you want the marked G code
blocks to be executed again during the next run. (The softkey is
deactivated again.)
Load a program in "Machine Auto" mode (see Sec. "Starting/
stopping program execution").
Press the "Prog. Cntrl." softkey.
Press the "DRF offset" softkey.
Press the "Cycle Start" key.
Execution of the program starts. Offsets with the handwheel affect the
machining process directly.
Press the "DRF offset" softkey again if you no longer want to
allow handwheel offsets during machining. (The softkey is
deactivated again.)
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
Siemens AG, 2004. All rights reserved