Siemens SINUMERIK 840D Operation/Programming Manual page 122

2
Operation
2.10 Automatic mode
Selecting ShopMill cycle
Cycle Start
Cycle Start
Reset
2-122
Line:
Type:
Search target: Point in the program at which machining is to start
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Position the cursor on the desired target block.
Press the "Block search" and "Start search run" softkeys.
Start
search run
Where chained program blocks have several technology blocks,
select the desired technology block in the "Search run" window.
The prompt does not appear in the case of single program blocks.
Press the "Accept" softkey.
For chained program blocks, enter the number for the desired
starting position.
The prompt does not appear in the case of single program blocks.
Press the "Accept" softkey.
Press the "Cycle Start" key.
ShopMill carries out all necessary default settings.
Press the "Cycle Start" key again.
The new starting position is approached. The workpiece is then
machined from the beginning of the target block.
You can abort the search by pressing the "Reset" key.
Parameter is assigned by ShopMill
" " Search target is ignored on this level
N no. Block number
Marker Jump marker
Text Character string
Sub-r. Subprogram call
Line Line number
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
 Siemens AG, 2004. All rights reserved